How to prepare uranium dioxide acetate solution
All kinds of utensils and materials should be prepared in advance. The required materials, uranium dioxide acetate powder must be pure, and the solvent should be pure water.

First, take a clean container to ensure that there are no impurities. According to the concentration of the proposed solution, accurately weigh the appropriate amount of uranium dioxide acetate powder. The amount weighed should be carefully calculated according to the predetermined concentration and the total volume of the solution.

Next, slowly pour the weighed uranium dioxide acetate powder into a container already filled with an appropriate amount of water. When pouring, gently stir it with a glass rod to cause the powder to dissolve gradually. When stirring, use force to be uniform at a moderate rate to prevent the solution from splashing out and help it dissolve fully.

During the dissolution process, it may be slow to dissolve. At this time, the source can be slightly heated to make the water temperature rise slightly, but the temperature should not be too high, so as not to affect the properties of the solution. At the same time, continue to stir until the uranium dioxide acetate powder is completely dissolved, and the solution is in a uniform and clear state.

After complete dissolution, let the solution stand for a while to allow any fine particles that may exist to settle. Then, filter the solution with filter paper or microporous filter membrane to remove undissolved impurities or fine particles to ensure that the resulting uranium dioxide acetate solution is pure and free of impurities. Only then can the desired uranium dioxide acetate solution be obtained.