Preparation of Uranium Dioxide Acetate
If you want to make uranium dioxide acetate, you must be careful and careful.

First take an appropriate amount of uranium oxide and put it in a clean container. Slowly inject acetic acid, the amount of acid should be appropriate, neither excessive nor indispensable. In the meantime, it is advisable to stir it lightly so that the two are fully mixed.

Put the mixture on a warm fire and let it be slightly hot. The fire should not be fierce, lest it lose its properties. And stir it constantly to urge it to respond. When it is finished, the solution gradually clarifies.

Then, filter the resulting liquid with a fine filter to remove its impurities and obtain a clear liquid.

Then transfer the clear liquid to another container and steam it slowly at low temperature. When it is slightly concentrated, remove it from the heat source and let it sit in a cool place. After a long time, the crystals of uranium dioxide acetate will come out.

Collect the crystals, wipe them with a clean cloth, and place them in a dry place. The method of making uranium dioxide acetate is roughly like this, but when operating, you must be careful to get the best.