The method of making nickel acetate
If you want to make nickel acetate, you should start with nickel and supplement it with acetic acid. Take pure nickel first, wash the dirt on it, and make it clean and free of impurities. Nickel is firm and stable in quality, and is the basis for making nickel acetate.

It is to put the net nickel in the kettle, and slowly inject acetic acid. Acetic acid, the taste is sour and strong, and when it meets nickel, it gradually begins to combine. During this time, the temperature should be controlled, and it should not be too hasty. If the temperature is high, the rate of melting may be unexpected; if the temperature is low, it will slow down, which is time-consuming and laborious. Moderate temperature, about [X] degrees, this temperature can make the combination of the two orderly.

When the mixture is combined, the liquid in the kettle gradually changes, and the color or turns light green, which is a sign of the gradual formation of nickel acetate. And sometimes there are bubbles escaping, which is the gas generated by the reaction. When the bubbles are gradually diluted and the reaction slows down, it can be seen that the combination is near the end.

After that, the resulting liquid is filtered with filter paper to remove the unmelted nickel and impurities. The filtrate is a solution containing nickel acetate. Then put the liquid into an evaporation dish and steam slowly over low heat. The water vapor gradually dissipates, and the solution gradually thickens. When there is an image of crystallization, move the dish to a cool place to allow it to crystallize naturally.

After a while, it crystallizes, which is nickel acetate. Its crystal color is beautiful, and its shape is like a star, which can be collected and used. The method of making nickel acetate is probably like this, and it is necessary to abide by the steps and control its conditions before you can get good products.