The method of laser cutting cellulose acetate
There is a technique today to cut cellulose acetate with a laser. This technique also requires that the cellulose acetate be placed in a suitable place to be stable and solid, so that there is no risk of shaking.

Then, adjust the laser device to control its energy and the degree of coagulation. The size of the energy is related to the speed and quality of the cutting. If the energy is large, the cutting speed will be disorderly, and the surrounding area will be damaged; if the energy is small, the cutting speed will be slow, and the material may be difficult to break. The degree of coagulation is also heavy, and when the laser is accurately concentrated on the surface of cellulose acetate, a fine cut can be made.

When operating, you must carefully observe the laser's behavior and follow the traces. And it is necessary to prevent the appearance of overheating. If there is too much heat accumulation, cellulose acetate may be deformed or carbonized. It can be accompanied by air-cooling and water-cooling methods to dissipate its heat and ensure the properties of the material.

After cutting, check the obtained piece in detail. Looking at the edge, it should be neat and smooth, without jagged teeth or burrs. The size must also be in line with the previous regulations, with no difference in the millimeter. If there is any failure, the cause should be investigated, adjusted, and re-cut, and the service period will be good.

This method can be used to obtain fine cellulose acetate cutting parts for various uses.